nctcog logo
 
transportation label

 

 
Diesel Inspection and Maintenance Demonstration Programs

In the Dallas-Fort Worth region, approximately 48 percent of on-road emissions of nitrogen oxides are attributable to heavy-duty diesel vehicles, yet these vehicles are excluded from the State’s Inspection and Maintenance (I/M) Program. To evaluate the feasibility of incorporating diesel vehicles into the I/M Program, the North Central Texas Council of Governments (NCTCOG) partnered with the Texas A&M Transportation Institute (TTI), the Texas Department of Public Safety, the Texas Department of Transportation and the University of Denver through the Heavy-Duty Diesel I/M Pilot Program – Phase 1 study to test a prototype of a new emissions testing technology called the Streamlined Heavy-Duty Emissions Determination (SHED).

In June 2012, a prototype of the SHED was constructed at the New Waverly Weigh Station, along IH 45, and successfully deployed for the Pilot Program – Phase 1 study. Emissions data from nearly 1,500 heavy-duty diesel vehicles (HDDV) were collected during a two week testing period. SHED data was validated by comparing readings to a control group of ten HDDVs for which emissions data was also evaluated utilizing a Portable Emissions Measurement System (PEMS). The data from the SHED compared favorably with the PEMS readings, clearly demonstrating that this technology is a viable option to be considered for emissions testing of HDDVs, and potentially other types of vehicles.

SHED PIC

In July 2015, NCTCOG and TTI partnered to start the second phase of testing the On-Road Heavy-Duty Emissions Measurement System (OHMS), which was previously known as SHED.  This study had two main objectives, the first of which was to refine the OHMS design used in Phase 1 and investigate other technologies that can be logically integrated with the OHMS setup for enhanced measurement capabilities.  The second objective was to deploy the improved design at a selected location through a field test, where real-world data will be collected and final enhancements to the system can be identified.  The research facility testing ran spring 2016, and the real- world field testing occurred in the fall of 2016. The final report for both studies can be found below.

SHEDTruck

Demonstration Resources (click on the titles below for more information)

 

PHASE 1

Heavy-Duty Diesel I/M Pilot Program – Phase 1 Final Report [PDF]

Heavy-Duty Diesel I/M Pilot Program – Phase 1 Poster [PDF]
Heavy-Duty Diesel I/M Pilot Program – Phase 1 Results Presentation [PDF]

Alternative Method for Measuring Real-Time Heavy-Duty Diesel Emissions [PDF]

 

PHASE 2
Heavy-Duty Diesel I/M Pilot Program- Phase 2 Final Report [PDF]

Heavy-Duty Diesel I/M Pilot Program - Phase 2 Results Presentation [PDF] NEW


A similar prototype was deployed in the Vancouver, Canada metro area and performed by Envirotest Canada.  Click here for the study.

 

In addition to these studies, future studies will continue to be aimed at identifying high-emitting diesel vehicles and encouraging the repair or replacement such vehicles in order to reduce truck emissions and improve air quality in the region. 

Staff

Jason Brown  
Shannon Stevenson
Principal Air Quality Planner
Program Manager
817-704-2514 
817-608-2304
sstevenson@nctcog.org

12/5/2017 SD/JB//MG %Trans  

 CONTACT US | SITE MAP | LEGAL | SYSTEM REQUIREMENTS
 North Central Texas Council of Governments | 616 Six Flags Drive P.O. Box 5888 Arlington, TX 76005-5888
 Main Operator: (817) 640-3300 | Fax: (817) 640-7806